74ALVCH16600集成電路（IC）的通用總線功能規(guī)格書PDF中文資料

1 General description

The 74ALVCH16600 is an 18-bit universal transceiver featuring non-inverting 3-state

bus compatible outputs in both send and receive directions. Data flow in each direction

is controlled by output enable (OEAB and OEBA), latch enable (LEAB and LEBA),

and clock (CPAB and CPBA) inputs. For A-to-B data flow, the device operates in the

transparent mode when LEAB is HIGH. When LEAB is LOW, the A data is latched if

CPAB is held at a HIGH or LOW logic level. If LEAB is LOW, the A-bus data is stored in

the flip-flop on the HIGH-to-LOW transition of CPAB. When OEAB is LOW, the outputs

are active. When OEAB is HIGH, the outputs are in the high-impedance state. The HIGH

clock can be controlled with the clock-enable inputs (CEBA and CEAB).

Data flow for B-to-A is similar to that of A-to-B, but uses OEBA, LEBA and CPBA.

To ensure the high impedance state during power up or power down, OEBA and OEAB

should be tied to VCC through a pullup resistor; the minimum value of the resistor is

determined by the current-sinking/current-sourcing capability of the driver.

Active bus hold circuitry is provided to hold unused or floating data inputs at a valid logic

level.

2 Features and benefits

? CMOS low power consumption

? MultiByte flow-through standard pin-out architecture

? Low inductance multiple VCC and GND pins for minimum noise and ground bounce

? Direct interface with TTL levels (2.7 V to 3.6 V)

? Bus hold on data inputs

? Output drive capability 50 Ω transmission lines at 85 °C

? Current drive ±24 mA at 3.0 V

? Complies with JEDEC standards:

– JESD8-5 (2.3 V to 2.7 V)

– JESD8B/JESD36 (2.7 V to 3.6 V)

? ESD protection:

– HBM ANSI/ESDA/JEDEC JS-001 exceeds 2000 V

– CDM JESD22-C101E exceeds 1000 V