5014-842中文資料安普數據手冊PDF規(guī)格書

Description

The Si2035 is a programmable stepper drive/

indexer packaged in a rugged steel case . Integral

heat sink, mounting brackets, switch covers and

connectors are included with each Si2035. The

drive/indexer has been matched with nine

recommended NEMA 11, 14, 17 and 23 motors

and comes with all operating software necessary to

create a complete stepper motion solution.

The Si2035 includes Applied Motion Products' ,

Microsoft Windows based, Si? software language

for quick set up and ease of use. The Si? is ideal

for stand-alone operation. For more experienced

users, with software development expertise, the

Si2035 also comes with Applied' s Si Command

Language (SCL) programming instruction set. SCL

allows for control of the Si? drive from a host PC

or PLC thus permitting the user to perform a

variety of motion, I/O tasks and system status

retrieval via the host.

Multiple axis applications are handled by our

SiNet? Hub Programmer, which gives you the

ability to control up to 8 Si? drives, either stepper

or servo on the same hub. Not only can you

coordinate up to eight motors, the hub also has

access to the inputs and outputs of all the drives,

providing your program with up to 64 inputs and

24 outputs. You can also use Applied' s MMI

which allows the machine operator to enter

specific motion commands. Factory set to operate

at 110-volt input; the Si2035 can be set by the user

to operate at 220-volt input by a simply switch

selection.

Pluggable screw terminal blocks are provided for

the I/O, motor and AC power inputs. Mating

connectors, programming cable with computer

interface connector as well as all operating

software are provided with each Si? drive.

Features:

? Si? , Si Command Language (SCL) or SiNet Hub programming

languages included with drive

? AC input 110V or 220V switch selectable, 50-60 Hz

? DC bus voltage 28 VDC full load, 35 VDC nominal

? Software selectable motor current from 0.2 - 2.0 amps/

phase

? Software selectable motor resolution from 2,000 to

50,800 steps per revolution

? Software selectable idle current reduction 0, 25, 50

or 100

? Eight optically isolated programmable inputs 12 – 24

VDC. 2,200 ohms internal resistance. Can be configured

for sinking (NPN) or sourcing (PNP) signals.

? Three optically isolated programmable outputs 30V max

VDC, 100mA maximum

? One 0 - 5 VDC analog input ( supported by SCL only )

? RS-232 for PC/MMI communications

? Dual H-bridge, pulse width modulated amplifier switching

at 26 KHz